Pokédex 3D printed case Prop ( DIY Kit )

NOTE: this listing is for a RAW 3D print only cleaning/sanding/painting/decorating is up to you.

This kit includes:

• Back case
• Flap cover
• Metal rod for hinge
• Metal Screw for bottom half of case
• 2mm Foam padding for tight fit and to protect the back of your phone

ASSEMBLY INSTRUCTIONS:

1 – Slide metal rod through both parts and screw it in closed at bottom end.

2 – Lay parts flat and place foam padding on inside of case (leave clearance at the very top so that it doesn’t obstruct camera)

3 – Slide top half of phone into the top part of the case until the rear camera is centered in the back opening of the case.

4 – Press bottom of phone tightly into bottom recess until you feel a satisfying snap ( metal edge of phone should be hidden & only the glass surface should show at edges )

5 – Impress your friends & enjoy ^_^

HINT:

You may decide to remove the bottom screw and just glue the rod to the top and bottom hinges with hot glue or super glue if you want the case to remain whole when not in use.